Which two of these changes are necessary for SwitchA to meet the requirements?
Refer to the exhibit.
A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network throught port fa0/1.
If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observe the output from these two show commands.
Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two)
Which (config-router) command will allow the network represented on the interface to be advertised by RIP?
Refer to the exhibit. Which (config-router) command will allow the network represented on the interface to be advertised by RIP?
What command sequence will enable PAT from the inside to outside network?
Refer to the exhibit. What command sequence will enable PAT from the inside to outside network?
Which value will be configured for Default Gateway of the Local Area Connection?
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?
which OSI layer is the problem?
Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?
Which two command sets, if issued, resolve this failure and allow VTP to operate as expected?
Refer to the exhibit.
The VLAN configuration of S1 is not being updated in this VTP-enabled environment. The VTP and uplink port configuration for each switch are displayed. Which two command sets, if issued, resolve this failure and allow VTP to operate as expected?
what is the most likely problem?
Refer to the Exhibit.
All Switches ports are assigned to the correct VLANs, but none of the hosts connected to switchA can communicate with hosts in the same VLAN connected to switchB. Based on the output shown, what is the most likely problem?
what is the problem on the Brevard router that is causing the lack of connectivity?
Two routers named Atlanta and Brevard are connected by their serial interfaces as shown in the exhibit, but there is no data connectivity between them. The Atlanta router is known to have a correct configuration. Given the partial configurations shown in the exhibit, what is the problem on the Brevard router that is causing the lack of connectivity?
which IP addresses would be assigned to the interfaces with point-to-point PVCs?
Refer to the exhibit.
In the Frame Relay network, which IP addresses would be assigned to the interfaces with point-to-point PVCs?
What is the TTL value for the ping?
Refer to the exhibit.
Host A pings interface S0/0 on router 3. What is the TTL value for the ping?