What can be determined about the router from the console output?
Refer to the exhibit. What can be determined about the router from the console output?
Which WAN protocol is being used?
Refer to the exhibit. Which WAN protocol is being used?
Which two steps should be taken no restore reachability to R3?
Refer to the exhibit. Your customer has enabled IPv6 and IPv4 on routers R1 and R2, both running ISIS routing protocol, and they can no longer reach R3 network 172.26.15.0/24 (R3 does not enable IPv6, enables IPv4 only).
Which two steps should be taken no restore reachability to R3? (Choose Two.)
What type of connection would be supported by the cable diagram shown?
Refer to the exhibit. What type of connection would be supported by the cable diagram shown?
Pin Number
Color
Function
Color
Function
1
White/Green
TX+
1
White/Green
TX+
2
Green
TX-
2
Green
TX-
3
White/Orange
RX+
3
White/Orange
RX+
6
Orange
RX-
6
Orange
RX-
What is needed to allow communication between VLANs?
Refer to the exhibit.
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs.
What is needed to allow communication between VLANs?
What two facts can be determined from WLAN diagram?
Refer to the exhibit.
What two facts can be determined from WLAN diagram? (choose two)
Which three values could be used for the configuration of these hosts?
Refer to the exhibit.
A network administrator is adding two new hosts to SwitchA.
Which three values could be used for the configuration of these hosts? (Choose three)
what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN2?
Refer to the exhibit.
Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN2?
Which statement is true?
Refer to the exhibit. A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true?
When two hosts are trying to communicate across a network
When two hosts are trying to communicate across a network, how does the host originating the communication determine the hardware address of the host that it wants to "talk" to?