Referring to the exhibit, if RTP header compression is used on the link, the header??s overhead on the voice packet will be reduced by what percent? (Exhibit)

R3 and R4 are Route-Reflectors and there is an I-BGP session between them, there is NO I-BGP session between R1 and R2. For an External Route from CE-2 in R2 to reach R1, which two statements are true? (Exhibit)

With the BGP peerings shown, which 3 solutions are most correct? (Exhibit)

In the diagram, R1 is the head-end of a TE tunnel that terminates on R5. The red line indicates the protected link, and the gold line indicates the backup tunnel. Which router is the Point of Local Repair? (Exhibit)

Which MQC-based output queueing method is designed to support multiple traffic classes including VoIP traffic, mission-critical traffic, bulk traffic, interactive traffic and default class traffic?

What Cisco IOS feature examines packets received to make sure that the source address and interface are in the routing table and matck the interface that the packet was received on?

BGP best route selection process is based on what ?

Based on the following output in R1, which statement is true R1#show mpls forwarding-table 50.0.0.3 detail
Local Outgoing Prefix Bytes Outgoing Next Hop
tag
interface
tag tag or VC or Tunnel Id switched
19 17 50.0.0.3/32 0 Et0/0 192.168.0.14
——-

The layer 2 protocol used by POS technology offers a standarized way for mapping IP packets into SONET/SDH payloads. Select the correct sequence of POS operation.

1) Data is scrambled and synchronous mapping takes place by octet into the SONET/SDH frame.
2) Encapsulated via Point-to-Point Protocol (PPP) takes place framing information is added with High-level Data Link Control (HDLC).
3) Gaps between frames are filled with flags, set to value 7E.
4) Octet stuffing occurs if any flags or resultant escape characters (of value 7D) are found in the data.
5) Data is segmented into an IP datagram with its 20-byte IP header.