Which task or set of tasks does the administrator need to complete to enable all hosts on DMZ2 to make HTTP co
Refer to the exhibit. The network administrator for this site wants hosts on DMZ2 to be able to make HTTP connections to host 172.16.1.10. Hosts on DMZ2 are currently unable to make these connections.
The network administrator checks the security appliance and determines that there are no access lists configured on either the DMZ1 or DMZ2 interface.
Which task or set of tasks does the administrator need to complete to enable all hosts on DMZ2 to make HTTP connections to host 172.16.1.10?
Which two statements about configuring passive RIP on the security appliance are true?
Refer to the exhibit. Which two statements about configuring passive RIP on the security appliance are true? (Choose two.)
what two ways can you decrease the amount of time it takes for an active Cisco ASA
In what two ways can you decrease the amount of time it takes for an active Cisco ASA adaptive security appliance to fail over to its standby failover peer in an active/active failover configuration? (Choose two.)
Which route or routes will Router B receive?
Refer to the exhibit. It shows an MPLS network with four routers as well as two customer routers. Router E is advertising the network 192.168.12.0/24. Rather than propagating the 192.168.12.0/24 network, Router D aggregates the 192.168.12.0/24 route into 192.16.0.0/16. Which route or routes will Router B receive?
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in a multifloor building with a WLAN that operates at an 11 MB/s data rate, how many decibels referenced to 1 milliwatt of same-channel separation are recommended between floors?
What does Reverse Route Injection enable in this configuration?
Refer to the exhibit. What does Reverse Route Injection enable in this configuration?
What will each of these options do if chosen?
Study the following exhibit carefully. You have been tasked to administrate a new Cisco ASA security appliance with a Cisco ASA CSC-SSM. You are using the CSC Setup Wizard from within Cisco ASDM to configure the CSC-SSM for traffic selection. In the process of the configuration of traffic selection, the CSC Setup Wizard asks If CSC card fails and provides two options.
What will each of these options do if chosen? (Choose two.)
when it is not activated?
Refer to the exhibit. You are the administrator of a Cisco ASA security appliance with a Cisco ASA CSC-SSM. You have upgraded the CSC-SSM with a new version of software. When the upgrade has finished, you issue the show module 1 detail command; the results of the command are shown in the exhibit.
Why does the command output show that the status of the CSC-SSM is "Up" when it is not activated?
which address pool will be used by the Cisco ASA security appliance for the NAT?
According to the following exhibit. When a host on the inside network attempted an HTTP connection to a host at IP address 172.26.10.100, which address pool will be used by the Cisco ASA security appliance for the NAT?
what will be the number of simultaneous logins allowed for this user?
Refer to the exhibit. An administrator is editing user-specific policy. The administrator has configured a group policy for Sales to use the IP address pool that is defined by the pool VPNPOOL and to allow as many as three simultaneous logins.
Based on the exhibit, when this user connects, what will be the IP address assigned to the connection and what will be the number of simultaneous logins allowed for this user? (Choose two.)