Refer to the exhibit:

A network associate needs to configure the switches and router in the graphic so that the hosts in VLAN3 and VLAN4 can communicate with the enterprise server in VLAN2. Which two Ethernet segments would need to be configured as trunk links? (Choose two.)

Refer to the exhibit:

When PC1 sends an ARP request for the MAC address of PC2, network performance slows dramatically, and the switches detect an unusually high number of broadcast frames. What is the most likely cause of this?

Refer to the exhibit:

The show vtp status command is executed at a switch that is generating the exhibit output. Which statement is true for this switch?

Refer to the exhibit:

After SwitchB was added to the network, VLAN connectivity problems started to occur. What caused this problem?

Refer to the exhibit:

How should the FastEthernet0/1 port on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?

Refer to the exhibit:

A network administrator needs to add a new VLAN, named VLAN3, to the network shown. Unfortunately, there is not another FastEthernet interface on R1 to connect to the new VLAN3. Which approach is the most cost effective solution for this problem?

Refer to the topology and router output shown in the exhibit:

A technician is troubleshooting host connectivity issues on the switches. The hosts in VLANs 10 and 15 on Sw11 are unable to communicate with hosts in the same VLANs on Sw12. Hosts in the Admin VLAN are able to communicate. The port-to-VLAN assignments are identical on the two switches. What could be the problem?

Refer to the exhibit:

The network manager is evaluating the efficiency of the current network design. RIPv2 is enabled on all Layer 3 devices in the network. What network devices participate in passing traffic from the PC at 10.10.1.7 to File Server at 10.20.1.6 in the older that they will forward traffic from source to destination?

Refer to the exhibit:

An organization connect two locations, supporting two VLANs, through two switches as shown. Inter-VLANs communicated is not required. The network is working properly and there is fully connectivity. The organization needs to add additional VLANs, so it has been decided to implement VTP. Both switches are configured as VTP servers in the same VTP domain. VLANs added to Switch1 are not learned by Switch2. Based on this information and partial configuration is the exhibit, what is the problem?

Refer to the exhibit:

What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)