What will happen to HTTP traffic coming from the Internet that is destined for 172.16.12.10 if the traffic is
Refer to the exhibit:
What will happen to HTTP traffic coming from the Internet that is destined for 172.16.12.10 if the traffic is processed by this ACL?
What happens to the network when it is reconnected and a trunk exists between the two switches?
Refer to the exibit:
SwX was taken out of the production network for maintenance. It will be reconnected to the Fa 0/16 port of Sw-Ac3. What happens to the network when it is reconnected and a trunk exists between the two switches?
show vtp status (exhibit):
show vtp and show vlan (exhibit):
show vlan (exhibit):
what statement describes the operation of this switch?
Refer to the exhibit:
Given the output of the Floor3 switch, what statement describes the operation of this switch?
How many broadcast domains exist in the exhibited topology?
Refer to the exhibit:
How many broadcast domains exist in the exhibited topology?
Why did the remote connection fail?
Refer to the exhibit:
A network administrator is unable to connect remotely to a device and initiates a console session. The administrator executes the show ip interface brief command. Why did the remote connection fail?
What should be done to solve this problem?
Refer to the exhibit:
Configuration of both switches has been completed. During testing, the network administrator notices that users on SwitchA can not connect with users in the same VLAN on SwitchB. What should be done to solve this problem?
Which commands are required to resolve this problem?
Refer to the exhibit:
The network administrator has created a new VLAN on Switch1 and added host C and host D. The administrator has properly configured switch interfaces FastEthernet0/13 through FastEthernet0/24 to be members of the new VLAN. However, after the network administrator completed the configuration, host A could communicate with host B, but host A could not communicate with host C or host D. Which commands are required to resolve this problem?
What is the reason the trunk does not form, even thought the proper cabling has been attached?
Refer to the exhibit:
Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q-complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?
Why is SwitchC not receiving VTP updates?
Refer to the exhibit:
The network administrator has discorvered that the VLAN configuration of SwitchC is not synchronized with the rest of the switched network. Why is SwitchC not receiving VTP updates?
Exhibit:
what is the most likely problem?
Refer to the exhibit:
All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB. Based on the output shown, what is the most likely problem?