Refer to the exhibit.

Which command is simplest to configure routing between the regional office network 10.89.0.0/20 and the corporate network?

Which entity assigns IPv6 addresses to end users?

Which device allows users to connect to the network using a single or double radio?

When a router makes a routing decision for a packet that is received from one network and destined to another, which portion of the packet does it replace?

What is the default lease time for a DHCP binding?

A workstation has just resolved a browser URL to the IP address of a server. Which protocol will the workstation now use to determine the destination MAC
address to be placed into frames directed toward the sever?

Instructions
For both the Router and the Switch the simulated console mode needs to start and remain in enabled mode.
RouterA and SwitchA have been configured to operate in a private network which will connect to the Internet. You have been asked to review the configuration prior
to cabling and implementation.
This task requires the use of various IOS commands to access and inspect the running configuration of RouterA and SwitchA. No configuration changes are
necessary.
You will connect to RouterA and SwilchA via the console devices that are attached to each.
There are 4 multiple-choice questions with this task. Be sure to answer all of them before leaving this item. In order to score the maximum points you will need to
have accessed both SwitchA and RouterA.
NOTE: The configuration command has been disabled for both the router and switch in this simulation.

Which two of the following are true regarding the configuration of RouterA? (Choose two.)

Which RFC was created to alleviate the depletion of IPv4 public addresses?

Which NTP command configures the local device as an NTP reference clock source?

Which function enables an administrator to route multiple VLANs on a router?