You are configuring WLC high availability for an access point. Which statement is true?

Refer to the exhibit.

A network administrator is troubleshooting a client connection problem. In the process of collecting
information, a client debug is run on the controller for the device MAC address. What is the most
likely cause of the problem?

A network administrator is troubleshooting a problem of a CAPWAP access point that
intermittently disconnects from the WLC. The administrator is trying to determine when the
problem is happening. UDP port 514 is allowed. What is the best option for successfully gathering
comprehensive information about the problem?

Refer to the exhibit.

You are testing the mesh AP feature in your lab. You begin by changing the AP mode from local to
bridge on one of your Cisco 3500 Series APs. The AP reboots and attempts to rejoin the
controller, but it fails to do so. Based upon the information in the exhibit, which two of these
options would allow the AP to join the WLC? (Choose two.)

Refer to the exhibit.

A network administrator is configuring and installing an indoor mesh network using two CAPWAP
APs. The APs were out of the box and have already been installed in their designated locations.
The RAP is joined to the controller and configured appropriately, but the MAP is not visible on the
WLC. In the output shown, which of these explanations is the most likely reason for the issue?

Your customer is attempting to create two WLANs with identical SSIDs and identical Layer 2
security policies on their WLC 5508, without success. Which two of these actions would help
them? (Choose two.)

According to Cisco best practices, many features require the WLC to be synchronized with an
NTP server. For which of these options is time synchronization not required?

Refer to the exhibit.

The help desk informs you that some users cannot receive multicast video. Upon troubleshooting,
you determine that the users who are unable to receive the multicast video are all connected at 9
Mbps. Users that are connected at a data rate of 12 Mbps or higher are able to receive the
multicast video. Which data rate can you modify to fix the problem?

In order for MFP client protection to be required on the WLAN, which three of these requirements
must the client meet? (Choose three.)

Which of the following WLC feature is disabled by configuring the Passive Client feature?