When configuring NAC in-band to work with a Cisco WLC, which statement is true, from a WLC
perspective?

You have four Cisco WLCs and have deployed wired guest access, using a single guest VLAN for
all controllers. How can you achieve redundancy if the guest VLAN fails on the infrastructure
switches?

You are on the U.S. East Coast (EST time zone, UTC-5) and configure NTP on your Cisco WLC.
The Cisco WLC web GUI shows the correct time and date, but your APs are off by 5 hours. Which
statement is true?

Which three statements about the VideoStream feature (also known as MediaStream) on the

Cisco WLC are true? (Choose three.)

Refer to the exhibit.

Your manager has asked you to configure a remote office Cisco WLC to support local EAP
authentication. The manager wants the clients to use EAP-FAST. The LDAP server is Microsoft
Active Directory. All users, including the account that is used to bind to the LDAP server, are in the
default Users container in Active Directory. No RADIUS servers are configured on the Cisco WLC.
The client is using the latest Intel card and supplicant.
Why does the test client fail to authenticate?

What is the minimum number of rules that is necessary in a CPU ACL to allow all access from a
single VLAN to the management interface, yet prevent management access from all other VLANs
while permitting all other traffic?

A wireless network administrator needs to limit guest user TCP traffic to no more than 50,000 kb/s,
to conserve bandwidth on the guest WLAN. To do this, the administrator configures the average
real-time rate to 50,000 kb/s and the burst real-time rate to 60,000 kb/s. Why does a test of the
guest account show no restriction for the client TCP traffic?

Refer to the exhibit.

You are a senior wireless network administrator and have just completed the configuration of
TACACS+ on your production Cisco WLC server. You can successfully log into the Cisco WLC by
using your domain credentials. However, junior administrators, who have only local management
accounts on the Cisco WLC, are complaining that they can no longer log into the Cisco WLC GUI
or CLI. What is the cause of this problem?

After performing a wireless site survey, you determine that to achieve proper HR-DSSS coverage
within the rooms along a hallway area, the AP radios that service the hallway must be at 12 mW or
higher. After the APs are all installed, you note that RRM is decreasing the power on the AP radios
in the hallway to 6 mW. Which two methods can you use to prevent the HRDSSS AP radio power
levels from dropping below 12 mW? (Choose two.)

Refer to the exhibit.

You are testing coverage-hole detection in your lab. You are using the default Cisco WLC
coverage-hole detection configuration that is shown. You have 14 test clients, all associated to the
same AP. You move three of the clients far away from the AP so that they have an RSSI of -85
dBm or lower for 1 minute. To your surprise, you see precoverage-hole alarms, but no coveragehole alarm is triggered.
Which two scenarios explain this issue? (Choose two.)