Two routers named Atlanta and Brevard are connected by their serial interfaces as shown in the
exhibit, but there is no data connectivity between them. The Atlanta router is known to have a
correct configuration. Given the partial configurations shown in the exhibit, what is the problem on
the Brevard router that is causing the lack of connectivity?

The router console screen is rapidly displaying line after line of output similar to what is shown in
the exhibit. The help desk has called to say that users are reporting a slowdown in the network.
What will solve this problem while not interrupting network operation?

Refer to the exhibit.

Which two of the output fields could help you determine if a broadcast storm
has occurred? (Choose two.)

Refer to the exhibit.

After the power-on self test (POST), the system LED of a Cisco 2950 switch
turns amber. What is the status of the switch?

Refer to the exhibit.

A network technician has added host A to the network. Host A cannot
communicate on the network. A ping that is issued on the host to address 127.0.0.1 fails. What is
the problem?

Refer to the exhibit.

A network technician is attempting to use HyperTerminal to configure a new
router using the settings shown. What is the reason the technician is unable to connect to the
router?

Refer to the exhibit.

What could be possible causes for the “Serial0/0 is down” interface status?
(Choose two.)

Which line from the output of the show ip interface command indicates that there is a Layer 1
problem?

Refer to the exhibit.

Workstation A must be able to telnet to switch SW-A through router RTA for
management purposes. What must be configured for this connection to be successful?

Refer to the exhibit. Two buildings on the San Jose campus of a small company must be
connected to use Ethernet with a bandwidth of at least 100 Mbps. The company is concerned
about possible problems from voltage potential differences between the two buildings. Which
media type should be used for the connection?