What is the effect of the configuration that is shown?
Refer to the exhibit.
What is the effect of the configuration that is shown?
What will fix this problem?
After the router interfaces shown in the diagram have been configured, it is discovered that hosts
in the Branch LAN cannot access the Internet. Further testing reveals additional connectivity
issues. What will fix this problem?
How can this problem be corrected?
Refer to the exhibit.
Serial0/0 does not respond to a ping request from a host on the
FastEthernet0/0 LAN. How can this problem be corrected?
Which two commands would be applied to the S0/0 WAN interface, but not to the Fa0/0 LAN interface?
Refer to the exhibit.
The network administrator is configuring RTA to connect to a non-Cisco
network. Which two commands would be applied to the S0/0 WAN interface, but not to the Fa0/0
LAN interface? (Choose two.)
What are three problems with the network design as shown?
Refer to the exhibit.
The goal of this network design is to provide the most efficient use of IP
address space in a network expansion. Each circle defines a network segment and the number of
users required on that segment. An IP subnetwork number and default gateway address are
shown for each segment. What are three problems with the network design as shown? (Choose
three.)
which two ways will the routers in this network respond to this change?
Refer to the exhibit.
The network shown in the exhibit is running the RIPv2 routing protocol. The
network has converged, and the routers in this network are functioning properly. The
FastEthernet0/0 interface on R1 goes down. In which two ways will the routers in this network
respond to this change? (Choose two.)
what is the most likely cause of the problem?
The administrator is unable to establish connectivity between two Cisco routers. Upon reviewing
the command output of both routers, what is the most likely cause of the problem?
Which port can be used for a WAN T1 connection?
This graphic shows some common router ports. Which port can be used for a WAN T1 connection?
What kind of cable should be used to make each connection that is identified by the numbers shown?
Refer to the exhibit.
What kind of cable should be used to make each connection that is identified
by the numbers shown?
Which command or series of commands will accomplish these objectives?
Refer to the exhibit.
For security reasons, information about RTA, including platform and IP addresses, should not be
accessible from the Internet. This information should, however, be accessible to devices on the
internal networks of RTA. Which command or series of commands will accomplish these
objectives?