Refer to the exhibit.

An administrator cannot connect from R1 to R2. To troubleshoot this problem, the administrator
has entered the command shown in the exhibit. Based on the output shown, what could be the
problem?

Refer to the exhibit.

A TFTP server has recently been installed in the Atlanta office. The network administrator is
located in the NY office and has made a console connection to the NY router. After establishing
the connection they are unable to backup the configuration file and IOS of the NY router to the
TFTP server. What is the cause of this problem?

If a host experiences intermittent issues that relate to congestion within a network while remaining
connected, what could cause congestion on this LAN?

Refer to the exhibit.

The junior network support staff provided the diagram as a recommended configuration for the first
phase of a four-phase network expansion project. The entire network expansion will have over
1000 users on 14 network segments and has been allocated this IP address space.
192.168.1.1 through 192.168.5.255
192.168.100.1 through 192.168.100.255

What are three problems with this design? (Choose three.)

Refer to the exhibit.

Host A can communicate with Host B but not with Hosts C or D. How can the network
administrator solve this problem?

Refer to the exhibit.

A network administrator has configured a Catalyst 2950 switch for remote management by pasting
into the console the configuration commands that are shown in the exhibit. However, a Telnet
session cannot be successfully established from a remote host. What should be done to fix this
problem?

Refer to the exhibit.

The network administrator is testing connectivity from the branch router to the newly installed
application server. What is the most likely reason for the first ping having a success rate of only 60
percent?

CORRECT TEXT

Which two of the following are true regarding the configuration of RouterA? (Choose two.)
at least 5 simultaneous remote connections are possible only telnet protocol connections to RouterA are supported remote connections to RouterA using telnet will succeed
console line connections will nevertime out due to inactivity
since DHCP is not used on FaO/1 there is not a need to use the NAT protocol

Select three options which are security issues with the current configuration of SwitchA. (Choose
three.)

Select two options which are security Issues which need to be modified before RouterA is used?
(Choose two.)