The layer 2 protocol used by POS technology offers a standarized way for mapping IP packets
into SONET/SDH payloads. Select the correct sequence of POS operation.

1) Data is scrambled and synchronous mapping takes place by octet into the SONET/SDH frame.
2) Encapsulated via Point-to-Point Protocol (PPP) takes place framing information is added with
High-level Data Link Control (HDLC).
3) Gaps between frames are filled with flags, set to value 7E.
4) Octet stuffing occurs if any flags or resultant escape characters (of value 7D) are found in the
data.
5) Data is segmented into an IP datagram with its 20-byte IP header.

Select 3 AVPs (Attribute-Value Pair) which MUST be present in the ICRQ:

Which two options best describe the purpose of session ID and cookie field in a L2TPv3 packet?

As described in rfc 3270,short-pipe mode operstion, the PE to CE egress polices are based upon:

The Outer.1Q tag represents customer VLAN ID and inner.1Q tag represents Provider VLAN
(PVLAN )

BCP (Best Common Practices) 38/RFC 2827 Ingress and Egress Packet Filtering would help
mitigate what classification of attack?

Based on the following output in R1, which statement is true
R1#show mpls forwarding-table 50.0.0.3 detail
Local Outgoing Prefix Bytes tag Outgoing Next Hop
tag tag or VC or Tunnel Id switched interface
19 17 50.0.0.3/32 0 Et0/0 192.168.0.14

Which IOS features are used to avoid Routing loops when dynamic Routing protocols are used
between PE and CE in MPLS-VPN networks?

In a frame ,the MPLS label is imposed

What is used to provide read access to QoS configuration and statistics information on Cisco
platforms that support Modular QoS CLI (MQC)?