Refer to the exhibit.

A new IPv4 multicast-based video-streaming service is being provisioned. During the designvalidation tests, you realize that the link between the two buildings is carrying multicast traffic
even when there are no receivers connected to the switch in Building B and despite IGMPsnooping being enabled on both Layer 2 switches and IGMPv2 runs on the hosts. Which design
change will prevent the multicast trafficfrom being unnecessarily flooded throughout the
campus network?

On a VoIP solution design, which option shows one-way latency, packet loss, and jitter
measurements that ensure acceptable voice quality?

Two medium-sized companies recently merged and would like to share their two campus
buildings as soon as possible. Employees should be able to sit and work in either building. If
the IP addresses in the networks overlap, which virtualization technology could be deployed
quickly to achieve the business objective?

A company would like to distribute a virtual machine (VM) hosting cluster between three data
centers with the capability to move VMs between sites. The connectivity between data centers
is IP only and the new design should use the existing WAN. Which Layer 2 tunneling technology
do you recommend?

You are designing a large Frame Relay WAN for a customer. The routing protocol is OSPF. What
is the effect on the routing table if the WAN interfaces are configured as point-to-multipoint?

You are designing an Out of Band Cisco Network Admission Control, Layer 3 Real-IP Gateway
deployment for a customer.Which VLAN must be trunked back to the Clean Access Server from
the access switch?

Refer to the exhibit.

You are designing a network using the Multiple Spanning Tree Protocol for loop avoidance.
VLAN trunking is not allowed due to security requirements. Which option describes how you
can design this Layer 2 network while using untagged interfaces between both switches?

You are designing an IPv4 any source multicast redundancy solution. Which technology ensures
the quickest RP convergence?

A company supports IPv4 and IPv6 addresses, and they need to be able to support flow-based
translations for multiple IPv6 devices to a single IPv4 address. Which address family translation
design solution should be recommended?

You are tasked with implementing a 1000-phone remote access solution, where phone calls will
traverse a WAN edge router.Assuming all of the following features are supported in a
hardware-assisted manner, which of the following will have the most negative impact on the
delay of the packet?