Which command on a Cisco Nexus 5000 Series Switch will show the interface information
for port 10 on the connected FEX 100?

There is an ARP storm in VDC 1. Some users on VDC 2notice that ARP is not resolving for their gatewayon
the Cisco Nexus core. What is the cause?

You have enabled configuration synchronization between two Cisco Nexus 5548UP Switches. You create a
port channel on switch 1 and determine that it was not
synchronized with its peer. The peer switch can be pinged on the management VRF. When
you check your peer status, you receive a “peer notreachable” message in the command
output. What is the explanation for this?

Your customer has a dual Cisco Nexus 7010 Switches in its data center. Customer’s
representatives want to know how to determine if Cisco IOS ISSU is possible on the
switches as they are upgrading to version 6.0.4. Which command is useful to determine if
the upgrade will be non-disruptive?

When using a Cisco Nexus 5500 and Cisco Nexus 7000 Series Switch, how can a port channel interface be
configured?

Which command is used to check for potential vPC configuration consistency problems?

A customer is deploying multihop FCoE in its network. Which guideline must the customer
follow with respect to VE ports to make this deployment possible?

Refer to the output.
feature otv
otv site-vlan 2
otv site-identifier 256
!
interface ethernet 2/0
ip address 192.0.2.1/24
ip igmp version 3
!
interface ethernet 2/1
ip address 192.0.2.2/24
ip igmp version 3
!
interface Overlay1
otv control-group 239.1.1.1
otv join-interface ethernet 2/0
otv extend-vlan 3-100
!
interface Overlay2
otv control-group 239.1.1.1
otv join-interface ethernet 2/1
otv extend-vlan 101-115
Which command best represents where the control plane configurations are applied?

In a Cisco Data center network, what troubleshooting step would you do first when having a npv issue?

Customer encounters the problem as shown in the exhibit. What is the cause of the problem?