UCS-A# scope eth-uplink
UCS-A /eth-uplink # scope fabric a
UCS-A /eth-uplink/fabric # scope interface 2 3
UCS-A /eth-uplink/fabric/interface # create mon-srcMonitor23
UCS-A /eth-uplink/fabric/interface/mon-src* # set direction receive
UCS-A /eth-uplink/fabric/interface/mon-src* # commit-buffer
What does the command scope interface 2 3 in the above CLI command sequence do on a Cisco UCS blade
server?

A customer is configuring SAN pin groups in a CiscoUCS domain. The customer notices that pinning is not
working and traffic from the vHBA is not passing over the Fibre Channel uplink port. Which of these must be
done for pinning to work correctly?

A customer is configuring LAN pin groups in a CiscoUCS domain. The customer has two fabric interconnects
and would like to associate the pin group with onlyone interconnect. Which statement about this configuration
is true?

A customer is configuring an upstream disjoint Layer 2 network in a Cisco UCS domain. So far they have
configured the following:
Fabric Interconnects are in switching mode.
There is symmetrical configuration for high availability.
There are no overlapping VLANs.
Each vNIC is communicating with one disjoint Layer 2 network.
After validating the above, the customer is still having issues with network connectivity. What is theissue?

A customer is configuring a network control policy in a Cisco UCS domain. The network control policy
configures the network control settings for the Cisco UCS domain, including which three of these? (Choose
three.)

A customer is troubleshooting QoS in a Cisco UCS domain due to high packet drops in the network. The
customer has configured the vNIC and associated QoSpolicy, and changed the MTU from 1000 to 1200.
Packet drops still exist. What is the cause of thisissue?

A customer is configuring the dynamic vNIC connection policy in a Cisco UCS domain. Why is the dynamic
vNIC policy required?

What is the default number of dynamic vNICs that isspecified by the Cisco UCS Manager when creating a
dynamic vNIC connection policy?

Looking at the Equipment > Chassis > Servers > Server X view from the Cisco UCS Manager GUI, which tab
would you select to identify the fabric interconnect uplink associated with a given virtual circuit?

While attempting to boot a Cisco UCS server from SAN, you are unable to see the LUN. Which of these are
causing the problem? (Choose three.)