When a VLAN port configured as a trunk receives an untagged frame, what will happen?

Which high availability service is verified by the show standby command?

A network administrator enters the following switchcommands:
Switch (config)#interface range fa0/0-5
Switch(config-if-range)#switchport access vlan 2
What is the result of these commands?

During routine maintenance, GigabitEthernet1/0/1 onDSW1 was shut down. All other interfaces were up.
DSW2 became the active HSRP device for VLAN 101 as desired. However, after GigabitEthernet1/0/1 on
DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be
done to make the group for VLAN 101 function properly?

Categorize the high availability network resources or feature items on the left by dragging them to appropriate
resiliency or management level on the right.

Drag the port sates to their correct description.

Drag the steps from the left to the right that should be part of the verification plan.

Drag the attributes on the left to the types on VLAN designs that they describe on the right.

Drag the items to the proper locations.

Place the DTP mode with its correct description.