Which two technologies allow for FCoE via lossless Ethe…
Youhave been tasked with designing a data center interconnect as part of business continuity.
Youwant to use FCoE over this DCI to support synchronous replication. Which two technologies
allow for FCoE via lossless Ethernet or data center bridging? (Choose two.)
Which two options will accomplish this scenario?
Refer to the exhibit.
Service Provider A and Service Provider B have agreed to a strategic interconnect relationship
that will allow them access into each other’s geographies by using an inter-AS eBGP VPNv4multihop between route reflectors. Which two options will accomplish this scenario? (Choose
two.)
Which two options are characteristics of firewall trans…
Which two options are characteristics of firewall transparent mode operations in a firewall
solution design? (Choose two.)
Which two options provide the best loop protection in t…
Which three factors slow down network convergence?
Which three factors slow down network convergence? (Choose three.)
Which two mechanisms can be used to improve convergence…
You are designing a core MPLS-based network with a single OSPF area with no external routes.
Which two mechanisms can be used to improve convergence time during a failure? (Choose
two.)
Which three design components are recommended to guaran…
Refer to the exhibit.Company A is running a single-area OSPF, and Company B is running RIP as the IGP with no
overlapping IP address spaces. Company A has just acquired Company B and both networks
must be merged. Which three design components are recommended to guarantee connectivity
and redundancy between the two networks? (Choose three.)
Which three options apply to the use of the echo functi…
Youare working on a network design for Customer A. This design should consider fast
convergence features, and it was agreed that BFD should be used for faster link-transition
detection. Which three options apply to the use of the echo function in BFD? (Choose three.)
Which three options about the Overload Bit are true?
The Customer X network consists of an MPLS core, IS-IS running as IGP, a pair of BGP route
reflectors for route propagation, and a few dozens of MPLS-TE tunnels for specific tactical traffic
engineering requirements. The customer engineering department has some questions about
the use of the Overload Bit in the IS-IS networks and how it could be used to improve their
current network design. Which three options about the Overload Bit are true? (Choose three.)
Which two key aspects should be taken into account?
Refer to the exhibit.
Four customer sites are connected through an EoMPLS-based VPLS over an MPLS provider.You
are migrating from OSPF to multi-level IS-IS as the routing protocol to run on the four CE
routers, and connectivity between all four sites is required. Youwant to control which CE or CEs
will be elected as the Designated Intermediate System. Which two key aspects should be taken
into account? (Choose two.)