Which two OSPF network type combinations can you use in the design of a Phase 3 DMVPN
that requires spoke-to-spoke direct traffic? (Choose two.)

Which ISAKMP feature could be used within your design recommendation to reduce device
CPU load in a small scale setup for known active ISAKMP security associations?

What is the purpose of dynamically created tunnels using IPv6 multicast?

What is a characteristic of traffic shaping?

When you design a network that uses IPsec, where can you reduce MTU to avoid network
fragmentation?

You are designing an IEEE 802.1X solution for a customer, where the network supports a large
number of IP phones and printers. You plan to configure MAC address bypass for the phonesand printers. What is your primary design and security concern?

Refer to the exhibit.You are designing an MPLS network with Layer 3 VPNs, where the traffic path must be the same
in both directions inside the MPLS network to ensure that symmetric routing occurs. The sites
are connected to two PE routers. Which two design considerations will allow you to achieve
this symmetric routing? (Choose two.)

Refer to the exhibit.Assume that no multicast optimization is done on LAN switches A and B. Which two features
can be used to optimize multicast traffic forwarding in this situation? (Choose two.)

While designing a security solution, which three requirements would make you decide to
deploy an IPS sensor in inline mode? (Choose three.)

Refer to the exhibit.This OSPF network has just been deployed with four areas, but the hub-and-spoke area
frequently flaps. You must fix this design failure. Which two reasons describe why the
implementation of link-state summarization will minimize the effect of the instability in this
network? (Choose two.)