You are auditing the network design of a PIM BiDir multicast network. Which option is the most
appropriate multicast group source discovery design consideration for this design?

The network architect wants to reduce the OSPF database in the network by using
summarization techniques. In which two places in the network can summarization be applied
to maximum effect? (Choose two.)

Which technique can be used to deploy IPv6 services in an IPv4-only routed backbone
network?

Which two mechanisms can anycast RPs use to share multicast state information with other
RPs? (Choose two.)

In a routed access hierarchical campus design, the access-to-distribution Layer 2 uplink trunks
are replaced with Layer 3 point-to-point routed links. Why is it recommended that VLANs are
confined on a single access switch rather than span across multiple access switches?

The Database team will deploy a new clustering technology that uses IPv4, multicast-based
data replication, where the servers listen and transmit at the same time on multiple groups.
Multicast is not being run on the current network and there are no plans to enable it. New
Layer 2 switches will be purchased to connect new servers in order to keep multicast traffic off
the existing network. Which two features should the new switches support to provide good
multicast performance? (Choose two.)

A financial services company runs HSRP at the edge of its network to allow for redundancy for
the default gateway for its servers. The CTO of the company is concerned that the failover time
for HSRP is too slow and a different mechanism should be used. The network engineer
disagrees and believes that HSRP can provide the required fast down detection and failover for
the edge of the network. Which option is the fastest down detection and failover solution for
this HSRP environment?

What are two design characteristics of GETVPN? (Choose two.)

On a large-scale DMVPN network design, what are two DMVPN characteristics? (Choose two.)

Company Y is a mobile backhaul provider that uses microwave rings in their network. Which
low-cost, simple technology do you recommend to Company Y to ensure the fastest
convergence times in a ring topology?