How are IP multicast IGMP entries synchronized between vPC peers?

Which option describes the default roles available to RBAC on Cisco Nexus switches?

What does the command “IP ARP synchronize” do in a vPC configuration?

Nexus# sh ip igmp snooping vlan 120
IGMP Snooping information for vlan 120
IGMP snooping disabled
Optimised Multicast Flood (OMF) disabled
IGMP querier none
Switch-querier enabled, address 1.1.1.1, currently not running
IGMPv3 Explicit tracking enabled
IGMPv2 Fast leave disabled
IGMPv1/v2 Report suppression enabled
IGMPv3 Report suppression disabled
Link Local Groups suppression enabled
Router port detection using PIM Hellos, IGMP Queries
Number of router-ports: 0
Number of groups: 0
Active ports:
Po100 Po111
Which statement best describes what is depicted in the show command output?

What is the default Time to Live (TTL) value in Cisco FabricPath?

Assuming the local peer is 10.0.0.1 and the remote peer (configuration not shown) is 10.0.0.2,
which of these is used to configure PIM Anycast-RP on a Nexus 7000 switch?

When using Overlay Transport Virtualization (OTV), how do L2 multicast frames traverse the
overlay?

Which three statements best describe multicast operation on Cisco Nexus switches in a data
center? (Choose three.)

On a Cisco Nexus 7000 Series Switch, what is the purpose of this command?
switch# config terminal

switch(config)# mac address-table learning-mode conversational vlan 1-10
switch(config)#

Where is a typical request in the Cisco UCS XML API placed in the data management engine,
and, after the request is confirmed, what is updated?