The company and the company network have both been growing rapidly. Multiple adds, moves
and changes have been applied to the network. Your boss has asked you to troubleshoot a recent
OSPF synchronization problem that has arisen. There have been synchronization problems at
separate locations in the OSPF area 0. There have been reported link failures during the rapid
growth of the company network. You are required to resolve the OSPF problem. OSPF must be
able to converge when the network changes.
Refer to the information above to answer the following question.
Which configuration command on D1 (with a similar command on D2) will provide an immediate
solution to the missing route problem?

The company and the company network have both been growing rapidly. Multiple adds, moves
and changes have been applied to the network. Your boss has asked you to troubleshoot a recent
OSPF synchronization problem that has arisen. There have been synchronization problems at
separate locations in the OSPF area 0. There have been reported link failures during the rapid
growth of the company network. You are required to resolve the OSPF problem. OSPF must be
able to converge when the network changes.
Refer to the information above to answer the following question.
The log of d1 reports the following:

This event was anticipated due to maintenance; however, it resulted in excessive lost routes.
Which route should be the only one removed from the routing tables of the routers?

The company and the company network have both been growing rapidly. Multiple adds, moves
and changes have been applied to the network. Your boss has asked you to troubleshoot a recent
OSPF synchronization problem that has arisen. There have been synchronization problems at
separate locations in the OSPF area 0. There have been reported link failures during the rapid
growth of the company network. You are required to resolve the OSPF problem. OSPF must be
able to converge when the network changes.

Refer to the information above to answer the following question.
The R2 router has lost connectivity to R1. The following is R1s current route table:

Which expected route is missing from R1s route table based on the topology during the
maintenance period?

An administrator types in the command router ospf 1 and receives the error message:
“OSPF process 1 cannot start.” (Output is omitted.) What should be done to correctly set up OSPF?

During a recent OSPF election among three routers, RTA was elected the DR and RTB was
elected the BDR, as seen in the graphic. Assume that RTA fails, and that RTB takes the place of
the DR while RTC becomes the new BDR. What will happen when RTA comes back online?

Refer to the exhibit.

During the process of configuring a virtual link to connect area 2 with the
backbone area, the network administrator received this console message on R3:
*Mar 1 00:25:01.084: %OSPF-4-ERRRCV: Received invalid packet: mismatch area ID, from
backbone area must be virtual link but not found from 20.20.20.1, Serial 0
How should the virtual link be configured on the OSPF routers to establish full connectivity
between the areas?

OSPF is configured over a Frame Relay network as shown in the exhibit. All PVCs are active.
However, R1 and R3 fail to see all OSPF routes in their routing tables. The show ip ospf neighbor
command executed on R2 shows the state of the neighbors. What should be done to fix the problem?

Refer to the exhibit.

In the show ipv6 route output, what would the metric be for a summary route that summarizes all
three OSPFv3 routes displayed?

Study the exhibit below carefully.

In order to summarize all routes from area 0 to area 1, what must be configured on the router?

Refer to the exhibit.

Which three statements accurately describe the result of applying the exhibited route map?
(Choose three.)