Refer to the exhibit.

Given the output for this command, if the router ID has not been manually set, what router ID will
OSPF use for this router?

Refer to the exhibit.

What commands must be configured on the 2950 switch and the router to allow communication
between host 1 and host 2? (Choose two.)

Which two statements describe the process identifier that is used in the command to configure
OSPF on a router? (Choose two.)
Router(config)# router ospf 1

Refer to the exhibit.

For what two reasons has the router loaded its IOS image from the location that is shown?
(Choose two.)

Which three elements must be used when you configure a router interface for VLAN trunking?
(Choose three.)

Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)

A router receives information about network 192.168.10.0/24 from multiple sources. What will the
router consider the most reliable information about the path to that network?

What is the default maximum number of equal-cost paths that can be placed into the routing table
of a Cisco OSPF router?

Which command shows your active Telnet connections?

Which type of EIGRP route entry describes a feasible successor?