Which statement describes why the CE2 Loopback address is installed as an external OSPF route at the CE1 routi
Refer to the exhibit.
An engineer is looking the CE1 routing table for CE2 Loopback 0. Each CE runs OSPF with its PE.
Which statement describes why the CE2 Loopback address is installed as an external OSPF route
at the CE1 routing table?
Which two minimum configurations are required to connect these two routers?
Two customers have routers that run OSPF and belong to the same OSPF area. These two
routers are connected by an MPLS backbone and by a low-bandwidth point-to-point link (used as
a backup link). Which two minimum configurations are required to connect these two routers?
(Choose two.)
Which approach can be used to achieve this requirement?
An engineer is looking into a solution for two customers that are using the network prefix
10.10.1.0/24. The network engineer wants the network prefix to remain the same for both
customers, while maintaining unique network information for each. Which approach can be used
to achieve this requirement?
Which feature on the service provider PEs can allow communication among different sites?
An MPLS VPN service is deployed over an MPLS provider. A customer wants all sites to run BGP
with his provider, given that all CEs have the same AS value. Which feature on the service
provider PEs can allow communication among different sites?
Which option describes the router or routers that should be configured to accomplish the administrative goal o
Refer to the exhibit.
Customer ABC uses RFC 1918 addresses within its network. Customer ABC wants the Internet
access for all the branch offices to transit through the head office for security and NAT purposes.
The PE routers in the service provider network contain Internet routes in the global routing table.
Which option describes the router or routers that should be configured to accomplish the
administrative goal of the customer?
Which BGP attribute can prevent routes originated from the customer from being readvertised back to them?
A customer requests a MPLS VPN service with dual-home connection to the service provider.
Which BGP attribute can prevent routes originated from the customer from being readvertised
back to them?
Which two information points will be listed in the routing table?
A network engineer is looking for a specific VRF routing table in the PE router of an Service
Provider. Which two information points will be listed in the routing table? (Choose two.)
How can a CE device with IP address 1.1.1.2 be accessed by the PE device?
A network engineer wants to use Telnet to access a CE device in a VRF from a PE device that
runs Cisco IOS Software. How can a CE device with IP address 1.1.1.2 be accessed by the PE
device?
Which routers will be enabled with MDT to support a multicast VPN?
An ISP provides MPLS L3VPN services and is required to set up a multicast VPN. Which routers
will be enabled with MDT to support a multicast VPN?
which two options represent protocols that run between CSC-PE and CSC-CE?
In the Carrier Supporting Carrier (CsC) feature, which two options represent protocols that run
between CSC-PE and CSC-CE? (Choose two.)