PrepAway - Latest Free Exam Questions & Answers

Author: seenagape

What is the cause of the error?

The network administrator is adding a new N1Kv to the vCenter, however, the administrator does
not see the new switch under the networking tab of vCenter.
The administrator issues the following command on the VSM to troubleshoot:
VSM# show svs connections
connection VC:
ip address: 10.10.10.30
remote port: 80
protocol: vmware-vim https
certificatE. default
datacenter namE. DC1

DVS uuiD. 67 32 30 50 a6 d2 49 64-9e 1c 5f 49 e3 af 55 99
config status: Disabled
operational status: Disconnected
sync status: –
version: –
When attempting to fix the issue, the following error is seen:
VSM-PRI-188# conf
VSM-PRI-188(config)# svs connection VC
VSM-PRI-188(config-svs-conn)# connect
ERROR: [VMWARE-VIM] Extension key was not registered before its use
What is the cause of the error?

what is the cause of this issue?

Refer to the exhibit.

An ESX host is added to a distributed switch but is never seen as a module in VSM. Given below
configuration from VSM, what is the cause of this issue? (Choose two.)
VSM# show svs domain
SVS domain config:
Domain iD. 111
Control vlan: 500
Packet vlan: 501
L2/L3 Control modE. L2
L3 control interfacE. NA
Status: Config push to VC successful.