Which statement best describes implementing a Layer 3 EtherChannel?

Refer to the exhibit.

You have configured an interface to be an SVI for Layer 3 routing capabilities. Assuming that all
VLANs have been correctly configured, what can be determined?

Refer to the exhibit.

Which statement is true?

Refer to exhibit as:

Which statement about the EIGRP routing being performed by the switch is true?

You have configured a Cisco Catalyst switch to perform Layer 3 routing via an SVI and you have
assigned that interface to VLAN 20. To check the status of the SVI, you issue the show interfaces
vlan 20 command at the CLI prompt. You see from the output display that the interface is in an
up/up state. What must be true in an SVI configuration to bring the VLAN and line protocol up?

Refer to the exhibit, which is from a Cisco Catalyst 3560 Series Switch.

Which statement about the Layer 3 routing functionality of the interface is true?

Refer to the exhibit.

Host A and Host B are connected to the Cisco Catalyst 3550 switch and have been assigned to
their respective VLANs. The rest of the 3550 configuration is the default configuration. Host A is
able to ping its default gateway, 10.10.10.1, but is unable to ping Host B. Given the output in the
exhibit, which statement is true?

Which three statements about routed ports on a multilayer switch are true? (Choose three.)

DRAG DROP
You have a VLAN implementation that requires inter-VLAN routing using Layer 3 Switches.
Drag the steps from the left to trhe right that should be part of the verification plan. Not all choices will be used.

Which two steps are necessary to configure inter-VLAN routing between multilayer switches?
(Choose two.)