Which two interface configuration commands on the Cisco ME 3400-1 switch Fa 0/1 interface are required to supp
Refer to the topology diagram in the exhibit.
Which two interface configuration commands on the Cisco ME 3400-1 switch Fa 0/1 interface are
required to support the VLANs for Customer A to be trunked across the service provider network?
(Choose two.)
what is the cause of the EtherChannel problem?
Refer to the exhibit.
If the devices produced the given output, what is the cause of the EtherChannel problem?
when is the request platform software package expand file bootflash:image-name command required?
When upgrading a Cisco ASR 1001 Router, when is the request platform software package
expand file bootflash:image-name command required?
what order does it pass through each state?
When a router undergoes the exchange protocol within OSPF, in what order does it pass through
each state?
what interface is the IP address configured?
A network administrator creates a layer 3 EtherChannel, bundling four interfaces into channel
group 1. On what interface is the IP address configured?
Which Cisco router platform supports running either the Cisco IOS or IOS XR operating system?
Which Cisco router platform supports running either the Cisco IOS or IOS XR operating system?
What command sequence will configure a router to run OSPF and add network 10.1.1.0 /24 to area 0?
What command sequence will configure a router to run OSPF and add network 10.1.1.0 /24 to
area 0?
Which two IOS and IOS XR configurations are needed?
You want to configure HSRP between a Cisco IOS and a Cisco IOS XR router for the 192.0.2.0/24
subnet. Half of the PCs on the 192.0.2.0/24 subnet are configured to use 192.0.2.1 as the default
gateway, and the other half of the PCs are configured to use 192.0.2.254 as the default gateway.
The intent is to load balance the traffic across both routers.
Which two IOS and IOS XR configurations are needed? (Choose two.)
what value will OSPF use as its router ID?
Refer to the exhibit.
If the router Cisco returns the given output and has not had its router ID set manually, what value
will OSPF use as its router ID?
which two of the address-family command options in IS-IS configuration mode are valid?
On Cisco IOS XR software, which two of the address-family command options in IS-IS
configuration mode are valid? (Choose two)