The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is

impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default
and the router IDs are shown with each router.

Which routers are likely to have been elected as DR? (Choose two.)

Refer to the exhibit.

Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?

A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote
network.
If there are no static routes to the destination and none of the routes were redistributed, which route will be placed in the IP routing table?

Which two are advantages of static routing when compared to dynamic routing? (Choose two.)

What are two drawbacks of implementing a link-state routing protocol? (Choose two.)

Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?

What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?

Refer to the exhibit.

Which two statements are true about the loopback address that is configured on RouterB? (Choose two.)

Refer to the exhibit.

The network associate is configuring OSPF on the Core router. All the connections to the branches should be participating in OSPF. The link to the ISP should NOT
participate in OSPF and should only be advertised as the default route. What set of commands will properly configure the Core router?

Which statements are true about EIGRP successor routes? (Choose two.)