Which of the following statements is correct regarding EIGRP manual summarization?
(Select the best answer.)

Which of the following configurations is consistent with this routing protocol behavior?
(Select the best answer.)

You configure the routers on your network for OSPF operation. You want to configure the
network type so that all routers will automatically establish adjacencies with neighbor routers
without requiring the manual configuration of neighbor commands. Additionally, you want DR
elections to take place. Which of the following commands should you issue in interface
configuration mode? (Select the best answer.)

What will the AS Path look like to BGP speaking routers in AS 65101 to reach AS Path
65401? Choose the best answer.

When configuring EIGRP on new WAN technologies such as an MPLS VPN or Metro
Ethernet, it is important that an engineer understand what layer of the OSI model these
technologies function on to determine how EIGRP will form neighbor relationships. From the
choices below, choose the proper OSIlayer each WAN technology runs on. Choose two.

Which IOS show command gives you the following SLA tracking information output to the screen as shown below:
Track 1
Interface Serial0/1/0 ip routing
IP routing is Up
27 changes, last change 00:03:37
Tracked by:
1207165940
Choose the best answer.

A router has been configured with OSPF authentication on interface fa0/0. The OSPF
neighbor relationship is not forming. You issue a “debug ip ospf events” command and see
the following log message:
05:01:35: OSPF: Rcv pkt from 192.168.2.2, OSPF_VL0 : Mismatch Authentication type.
Input packet specified type 0, we use type 1
Using this information, which of the following is true? Choose the best answer.

Which of the following commands correctly configures an IPv6 address on an interface and
sets it to operate using RIPng with the name CCNP-lab? Choose the best answer.

An engineer wants to redistribute OSPF into EIGRP. They log in to the boarder router that
runs bothSPF and EIGRP and execute the following commands:
Router(config)#router eigrp 100
Router(config-router)#redistribute ospf 2
Router(config-router)#end
Router#
Unfortunately, this did not cause OSPF routes to redistribute into EIGRP.
What is likely the problem? Choose two.

When a router analyzes the OSPF LSDB to calculate the best route to each subnet for
internal routes, it does the calculations in a specific order. Which answer below puts the
calculations in the correct order of operation? Choose the best answer.