Refer to the exhibit.

Two routers are connected by Frame Relay and are running OSPF
between them. Each router has been configured with the appropriate network statements
under router ospf 1, but the routers are not forming an adjacency. Which of the following
three commands could be configured on each router to correct this problem? (Choose three.)
Select 3 response(s).

Your network has a mixture of Fast Ethernet and Gigabit Ethernet links. What needs to be
done to ensure optimal data routing when using OSPF? Select the best response.

To make OSPF area 4 totally stubby, the following command was issued on the ABR in
router configuration mode: area 4 stub
Which two things need to be done to finish making area 4 a totally stubby area? (Choose
two.)
Select 2 response(s).

Refer to the exhibit.

Router C was configured so that it could form an adjacency with three
OSPF neighbors, one connected to each of its three physical interfaces.
Which statement is correct about router C?

Select the best response.

RouterA#debug ip ospf events OSPF events debugging is on
RouterA#
04:43:16: OSPF: Rcv pkt from 10.3.0.2, Ethernet0/1, area 0.0.0.1 mismatch area 0.0.0.2 in the header
04:43:19: OSPF: Rcv hello from 10.100.100.3 area 0 from Ethernet0/0 10.1.0.1
04:43:19:OSPF: End of hello processing
Refer to the exhibits.

What can be done to fix the problem?
Select the best response.

Refer to the exhibit.

AS 65500 is not advertising the prefix 192.168.12.0/22 to its provider.
AS 65500 is running OSPF as its IGP.
Which of the following additions to the configuration is most likely to solve the problem? Select the best response.

Refer to the exhibit.

Router B is performing bidirectional redistribution between EIGRP and
OSPF. The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network.
However, it needs to be reachable from any network within the EIGRP domain. All other
networks should be seen in both domains.
Which change to router B would accomplish these goals?
Select the best response.

Refer to the exhibit.

EIGRP has been configured on router D. Router C is performing mutual
redistribution between EIGRP and OSPF. While verifying that the redistribution is functioning
properly, you discover that while router C has all of the EIGRP routes in its routing table,
router A does not have any routes from the EIGRP domain. What on router C may be the
cause of the problem? Select the best response.

Refer to the exhibit.

Router B and router C are performing mutual redistribution between
OSPF and EIGRP, and their default metrics are configured the same. Router D has equal
cost paths to networks where both paths are not really equal cost. For example, network
172.16.54.0 shows equal cost through both router B and router C, though in reality the cost
is greater using router C. Other routers, though not shown, are connected to the 172.16.54.0
and 172.16.55.0 networks, and the same issues exist to those routers and the networks
connected to them. What can be done so that data will be routed along the most optimal
path in the network?

Select the best response.

Refer to the exhibit.

ROUTE.com is planning to implement load balancing for traffic between
hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review
the implementation plan for this project. Which statement about the plan is true? Select the
best response.