Refer to the exhibit.

On the basis of the output of the show spanning-tree inconsistentports
command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?

Refer to the exhibit.

STP has been implemented in the network. Switch SW_A is the root
switch for the default VLAN. To reduce the broadcast domain, the network administrator
decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues
the command spanning-tree vlan 2 root primary on switch SW_

Refer to the exhibit.

The command switchport mode access is issued on interface
FastEthernet0/13 on switch CAT1. What will be the result?

Refer to the exhibit.

LACP has been configured on Switch1 as shown. Which is the correct
command set to configure LACP on Switch2?

Refer to the exhibit.

On the basis of the information that is generated by the show
commands, which two EtherChannel statements are true? (Choose two.)

Refer to the exhibit.

What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?

What must be the same to make multiple switches part of the same Multiple Spanning Tree
(MST)?

Refer to the exhibit.

Switch 15 is configured as the root switch for VLAN 10 but not for VLAN
20. If the STP configuration is correct, what will be true about Switch 15?

Which two statements are true about BPDU port-guard and BPDU filtering? (Choose two.)

Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is
configured on all switches in the network. SW_B receives this error message on the console port:

00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5
(not half duplex), with SW_A FastEthernet0/4 (half duplex) , with TBA05071417(Cat6K-B)
0/4 (half duplex).
What would be the possible outcome of the problem?