Drag the items to the proper locations.
DRAG DROP
This is a drag and drop question which is about the correct sequence of steps that a wireless
client takes during the process of association with an access point (AP). Drag the items to
the proper locations.
What configuration will isolate the servers from each other?
Refer to the exhibit.
The web servers WS_1 and WS_2 need to be accessed by external and
internal users. For security reasons, the servers should not communicate with each other,
although they are located on the same subnet. The servers do need, however, to
communicate with a database server located in the inside network. What configuration will
isolate the servers from each other?
Which of the following statements describing trunk links are INCORRECT?
You are the network administrator tasked with designing a switching solution for the
Company network. Which of the following statements describing trunk links are INCORRECT? (Select all that apply)
Which of the following actions are taken in a VLAN map that does not contain a match clause?
VLAN maps have been configured on switch R1. Which of the following actions are taken in
a VLAN map that does not contain a match clause?
Which of the following specifications is a companion to the IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) al
Which of the following specifications is a companion to the IEEE 802.1w Rapid Spanning
Tree Protocol (RSTP) algorithm, and warrants the use multiple spanning-trees?
what happens when a host with the MAC address of 0003.0003.0003 is directly connected to the switch port?
A Company switch was configured as shown below:
switchport mode access
switchport port-security
switchport port-security maximum 2
switchport port-security mac-address 0002.0002.0002
switchport port-security violation shutdown
Given the configuration output shown above, what happens when a host with the MAC
address of 0003.0003.0003 is directly connected to the switch port?
which three protocols are allowed through the switch port before authentication takes place?
In the use of 802.1X access control, which three protocols are allowed through the switch
port before authentication takes place? Select three.
Which of the following specification will allow you to: associate VLAN groups to STP instances…?
Which of the following specification will allow you to: associate VLAN groups to STP
instances so you can provide multiple forwarding paths for data traffic and enable load balancing?
Which interface or interfaces on switch SW_A can have the port security feature enabled?
Refer to the exhibit.
Which interface or interfaces on switch SW_A can have the port security feature enabled?
Which statement is true?
Refer to the exhibit.
Assume that Switch_A is active for the standby group and the standby device has only the
default HSRP configuration. Which statement is true?