Configure the user ports (all FastEthernet ports) so that the ports are permanently non-trunking
LAB
Refer to the Exhibit.
Configure the user ports (all FastEthernet ports) so that the ports are permanently non-trunking.
Which statement is true?
Refer to the exhibit.
Which statement is true?
which command sequence would correct the problem?
Refer to the exhibit.
The user who is connected to interface FastEthernet 0/1 is on VLAN 10
and cannot access network resources. On the basis of the information in the exhibit, which
command sequence would correct the problem?
Which statement about the EIGRP routing being performed by the switch is true?
Refer to exhibit as:
Which statement about the EIGRP routing being performed by the switch is true?
which interface command is used to convert a Layer 3 interface to a Layer 2 interface?
You need make configuration changes to an existing layer 3 switch in the Company network.
On a multilayer Catalyst switch, which interface command is used to convert a Layer 3
interface to a Layer 2 interface?
What is the result of entering the command spanning-tree loopguard default?
What is the result of entering the command spanning-tree loopguard default?
Which command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?
Refer to the exhibit.
The switchport output in Figure 1 displays the default settings of interface
FastEthernet 0/13 on switch SW1. Figure 2 displays the desired interface settings. Which
command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?
What must be true in an SVI configuration to bring the VLAN and line protocol up?
You have configured a Cisco Catalyst switch to perform Layer 3 routing via an SVI and you
have assigned that interface to VLAN 20. To check the status of the SVI, you issue the show
interfaces vlan 20 command at the CLI prompt. You see from the output display that the
interface is in an up/up state. What must be true in an SVI configuration to bring the VLAN
and line protocol up?
What command could you enter to display the trunking status of a module/port in the switch?
What command could you enter to display the trunking status of a module/port in the switch?
(Type in the answer below):
Which statement about the Layer 3 routing functionality of the interface is true?
Refer to the exhibit, which is from a Cisco Catalyst 3560 Series Switch.
Which statement about the Layer 3 routing functionality of the interface is true?