What is the possible outcome of the problem?
Refer to the exhibit and the partial configuration of switch SW_A and SW_B.
STP is configured on all switches in the network. SW_B receives this error message on the console port:
00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5
(not half duplex), with SW_A FastEthernet0/4 (half duplex), with TBA05071417 (Cat6K-B)
0/4 (half duplex).
What is the possible outcome of the problem?
Which two statements are true about best practices in VLAN design?
Which two statements are true about best practices in VLAN design? (Choose two.)
Which statement is true?
Refer to the exhibit.
Which statement is true?
which two sets of procedures are best practices for Layer 2 and 3 failover alignment?
Refer to the exhibit.
On the basis of the information provided in the exhibit, which two sets of
procedures are best practices for Layer 2 and 3 failover alignment? (Choose two.)
What can be concluded about VLANs 200 and 202?
Refer to the exhibit.
What can be concluded about VLANs 200 and 202?
which protocol would you use?
If you needed to transport traffic coming from multiple VLANs (connected between switches),
and your CTO was insistent on using an open standard, which protocol would you use?
what type of PVLAN port should the default gateway be configured?
A switch has been configured with PVLANs. With what type of PVLAN port should the
default gateway be configured?
what circumstances should an administrator prefer local VLANs over end-to-end VLANs?
Under what circumstances should an administrator prefer local VLANs over end-to-end
VLANs?
what does the "03" represent?
In the MAC address 0000.0c07.ac03, what does the “03” represent?
What are some virtues of implementing end-to-end VLANs?
What are some virtues of implementing end-to-end VLANs? (Choose two)