You have a customer that is building a new campus of four 3-story buildings that you have just
completed the site survey for. The customer is interested in the amount of rack space they will
need to allocate in either the building MDF or in the data center for controllers. Each building is
going to require 75 APs to support voice and data. How should the controllers be deployed to
provide the least number of controllers, the highest redundancy, and the easiest management?

You have completed a site survey for a customer that refurbishes/remanufactures automobile
engines. The site survey has determined that there are approximately 70 clients in the facility, but
because of the large number of engines as many as 2500 RFID tags will need to be tracked
through location services to provide historical location information and audit trails. The results of
the site survey require 60 APs for data and location services. How many version 7.0 controller(s)
will provide the most cost effective solution?

Customer requirements and a WLAN site survey require a Cisco 1250 AP operating at full
802.11a/b/g/n located approximately 150 meters from the closest IDF. What is the best solution to
provide wireless coverage to this portion of the customer’s facility?

What is the result of a Cisco 1250 AP deployed for 802.11a/b/g/n using optimized power (16.8 W)
with software version 7.0?

Refer to the exhibit.

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the
visual screen?

Refer to the exhibit.

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the
visual screen?

Refer to the exhibit.

After performing a Layer 1 survey using Cisco Spectrum Expert, what is the result indicated by the
visual screen?

Which item is more of an issue to outdoor wireless mesh deployment than indoor?

What is the vertical height that a MAP should not exceed for proper deployment?

Mesh APs are commonly mounted alongside a pole, meaning they are both vertically aligned and
the pole could partially block the mesh AP RF signal. What is the maximum degree angle to allow
for blockage of the antenna field of view?