Which choice best describes RF challenges for outdoor mesh site survey and deployment?

DRAG DROP
Drag from the left the Cisco recommended design limits for hop count and ratio of MAP to RAP when designing an indoor mesh network for voice and data, and drop them on to the appropriate category on the right.

DRAG DROP
Drag from the left the relative AP densities for data, voice, and location services, and drop them under the appropriate categories on the right.

DRAG DROP
Drag from the left the devices that would be considered highly mobile or nomadic, and drop them under the appropriate category on the right.

DRAG DROP
Drag from the left the preferred parameters without excess for location service survey and deployment, and drop them on the right.

DRAG DROP
Drag from the left the minumum requirements needed for a location based survey and deployment and drop them on the right.

DRAG DROP
Drag from the left the acceptable minimum cell overlap for data and voice cells for site survey and deployment.

DRAG DROP
Drag from the left the maximum power, and drop it under appropriate UNII channel band regarding the FCC domain when designing and deploying outdoor WLAN using 5 Ghz.

DRAG DROP
Drag from the left the material type, and drop it under its relative attenuation level on the right.

When performing a post-installation audit using the Ekahau Survey tool, which four steps are
associated with the passive portion of the audit? (Choose four.)