The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does
this mean?

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the
output from RouterA, what are two possible reasons for the failure? (Choose two.)

Refer to the exhibit.

The output that is shown is generated at a switch. Which three statements are true? (Choose
three.)

Refer to the exhibit.

When running EIGRP, what is required for RouterA to exchange routing updates with RouterC?

Which term describes a spanning-tree network that has all switch ports in either the blocking or
fowarding state?

What command is used to verify the DLCI destination address in a Frame Relay static
configuration?

Refer to the exhibit.

A technician has configured the FastEthernet 0/1 interface on Sw11 as an access link in VLAN 1.
Based on the output from the show vlan brief command issued on Sw12, what will be the result of
making this change on Sw11?

Refer to the exhibit.

What commands must be configured on the 2950 switch and the router to allow communication
between host 1 and host 2? (Choose two.)

Refer to the exhibit.

How will the router handle a packet destined for 192.0.2.156?

Refer to the exhibit.

Which two statements are true about interVLAN routing in the topology that is shown in the
exhibit? (Choose two.)