Refer to the exhibit.

The Layer 2 network uses VTP to manage its VLAN database. A network designer created all
VLANs on the VTP server (switch 1) and it has been advertised through VTP to all other VTP
clients (switches 2 through 4). Due to network growth, a network operator decided to add a new
switch between switch 1 and switch 3. The network operator has been instructed to use a
refurbished switch and use a VTP client. Which three of these has been instructed to use a
refurbished switch and use a VTP client. Which three of these factors should the network operator
consider to minimize the impact of adding a new switch? (Choose three.)

Refer to the exhibit.

R1 has two eBGP sessions to ISP1 and ISP2 (one to each ISP router), and R1 receives the same
prefixes through both links.
Which configuration should be applied for the link between R1 and ISP2 to be preferred for
incoming traffic (ISP2 to R1)?

Refer to the exhibit.

AS65000 has core network P1 – P6. The eBGP peers to another AS are through ASBR1-2 and
ASBR3-4. All business and residential customer POPs are connected to the P1 – P2 core.

AS65000 has decided to enable MPLS LDP on all BGP routers, and disable BGP on the core
network (P1 – P6). What is the drawback of this BGP core-free network?

Which four of these commands are required when implementing DMVPN? (Choose four.)

On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all
links. If the link between R1 and R2 fails, what is the maximum number of queries R3 will receive
for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once
(there are no dropped or retransmitted packets)?

If a port configured with STP root guard receives a superior STP BPDU, the port will be put into
which state?

Having multiple unknown unicast frames in a switch would most likely deplete which of these
resources?

Refer to the exhibit.

All routers in this network are configured to run OSPF on all their connected links. R1 is
redistributing 192.168.1.0/24 into Area 1. When the 192.168.1.0/24 network is disconnected from
R1, the network administrator notes that R4 and R3 both receive two OSPF updates. Since
192.168.1.0/24 is within Area 1, the network administrator thinks this may indicate incorrect
operation and calls technical support. Is this incorrect OSPF operation, and why or why not?

You are configuring the Cisco IOS DHCP Server to handle DHCP in a LAN. Which two of these
configurations are required in order for DHCP to work? (Choose two.)

Refer to the exhibit.

While performing an internal audit of your network, you come across this configuration in all of
your routers. Which three statements about this configuration are true? (Choose three.)