Refer to the exhibit. As a network administrator, you have configured a dual-rate, dual-bucket
policer in accordance with RFC 2698 on the serial interface of you router, connecting to your
provider. The SLA with your provider states that you should only send AF31 (limited to 150 kb/s),
AF32 (limited to 50 kb/s)and AF33 (best effort). Your service provider claims you are not
conforming to the SLA. Which two things are wrong with this configuration? (Choose two.)

Refer to the exhibit. You have noticed that several users in the network are consuming a great
deal of bandwidth for the peer-to-peer application Kazaa2. You would like to limit this traffic, and at
the same time provide a guaranteed 100 kb/s bandwidth for one of your servers. After applying the
configuration in the exhibit, you notice no change in the bandwidth utilization on the serial link; it is
still heavily oversubscribing the interface. What is the cause of this problem?

All of these are fundamental building blocks of differentiated services Traffic Conditioner Block
except which one?

When you are troubleshooting duplex mismatches, which two errors are typically seen on the fullduplex end? (Choose two.)

Which RMON group stores statistics for conversations between sets of two addresses?

Which of the following describes the appropriate port assignment and message exchange in a
standard TFTP transaction?

What two features in Cisco switches help prevent Layer 2 loops? (Choose two.)

Refer to the exhibit. Which switching feature is being tested?

When troubleshooting a network, the output of the command show interfaces indicates a large
number of runts. What is a runt?

You deployed new fibers in your network to replace copper spans that were too long. While
reconnecting the network, you experienced network problems because you reconnected wrong
fibers to wrong ports. What could you do to prevent this type of problem in the future, particularly
when connecting and reconnecting fiber pairs?