Refer to the exhibit.

We have IPv6 multicast configured between R5 and R6. Which two statements are true based on
the partial command output shown? (Choose two.)

How is RPF used in multicast routing?

Refer to the exhibit.

Which interface(s) will show ip rpf 1.1.1.2 indicate as RPF interface(s)?

Which command is used to enable SSM with the range 232.0.0.0 – 255.0.0.0?

Which command is used to enable SSM with the range 232.0.0.0/8?

Which value is used in the PIM TYPE field to indicate a register-stop message?

Multicast is being deployed in the network, and only ip pim sparse-dense mode has been
configured on all interfaces in the network to support a new video streaming application. No other
multicast configuration was applied anywhere in the network. Since enabling multicast, the
network monitoring tools show periodic spikes in link utilization throughout the network, even in
areas where the video application is not being used. What could be a possible cause?

Choose two commands that are required to enable multicast on a router, when it is known that the
receivers use a specific functionality of IGMPv3. (Choose two.)

Which multicast address is reserved for cisco-rp-announce?

What is the value in seconds of the “Max Response Time” in an IGMPv2 report message?