Can this behavior be changed?
Every time a typing mistake is made at the exec prompt of a router, the message from the router
indicates a lookup is being performed. Also, there is a waiting period of several seconds before the
next command can be typed. Can this behavior be changed?
which ATM layers?
The ATM reference model is composed of which ATM layers? (multiple answer)
which mechanism is used to continue forwarding packets during a switchover?
The OSPF RFC 3623 Graceful Restart feature allows you to configure IETF NSF in ultivendor
networks. When using OSPF Graceful Restart, which mechanism is used to continue forwarding
packets during a switchover?
What is true about the DLCI field in the Frame Relay header?
What is true about the DLCI field in the Frame Relay header?
What prerequisite is there for enabling BGP to run on this network?
You work as a network engineer for the company, you want to configure two BGP speakers to
form an EBGP session across a firewall. On the engineer’s network, the firewall always permits
TCP sessions that are initiated from the inside network (the network attached to the inside
interface of the firewall). What prerequisite is there for enabling BGP to run on this network?
CIDR is primarily used:
CIDR is primarily used:
which will be the result?
Two directly connected routers, R1 and -R2, are both configured for OSPF graceful restart. R2 is
able to switch packets in hardware, but R1 is not. If a network administrator logs on to R2 and
performs a system reload, which will be the result?
When this is detected, the retransmission is sent by:
Click the Exhibit button to view the topology.
Host 1 and Host 2 are on Ethernet LANs in different buildings. A serial line is installed between
two Cisco routers using Cisco HDLC serial line encapsulation. Routers A and B are configured to
route IP traffic. Host 1 sends a packet to Host 2. A line hit on the serial line causes an error in the
packet. When this is detected, the retransmission is sent by:
Which two steps below should you perform on the hub router while configuring EIGRP routing over DMVPN (mGRE tu
Which two steps below should you perform on the hub router while configuring EIGRP routing over
DMVPN (mGRE tunnel)? (Choose two.)
What two mechanisms are represented by the transverse waves in the X and Y direction?
Click the Exhibit button to view the diagram.
The exhibit shows the direction of light. What two mechanisms are represented by the transverse
waves in the X and Y direction?