In the figure, if OSPF were disabled on the DCC links between the nodes in the system:
Click the Exhibit button.
In the figure, if OSPF were disabled on the DCC links between the nodes in the system:
Which form of SONET switching requires the exchange of the K1 and K2 bytes between adjacent multiplexer and/or
Which form of SONET switching requires the exchange of the K1 and K2 bytes between adjacent
multiplexer and/or cross-connect locations for switching to occur properly?
which address or location will the router forward a packet sent to 192.168.32.1?
Based on the output provided in the exhibit, to which address or location will the router forward a
packet sent to 192.168.32.1?
D 192.168.32.0/26 [90/25789217] via 10.1.1.1
R 192.168.32.0/24 [120/4] via 10.1.1.2
O 192.168.32.0/19 [110/229840] via 10.1.1.3
What statement is correct concerning the shown configuration?
Click the Exhibit button to view the configuration.
What statement is correct concerning the shown configuration?
What effect will the as-path filter command that is configured on R4 create BGP routing table?
Refer to the exhibit.
What effect will the as-path filter command that is configured on R4 create BGP routing table?
what node would you put a static route to access this network from an external IP network?
Click the Exhibit button.
With a router connected to node E, and a laptop connected to node C, in what node would you put
a static route to access this network from an external IP network?
Which configuration should be applied for the link between R1 and ISP2 to be preferred for incoming traffic (I
Refer to the exhibit.
R1 has two eBGP sessions to ISP1 and ISP2 (one to each ISP router), and R1 receives the same
prefixes through both links.
Which configuration should be applied for the link between R1 and ISP2 to be preferred for
incoming traffic (ISP2 to R1)?
What is an active filter?
What is an active filter?
What is a good first test to see if BGP will work across the firewall?
Two routers configured to run BGP have been connected to a firewall, one on the inside interface
and one on the outside interface. BGP has been configured so the two routers should peer,
including the correct BGP session endpoint addresses and the correct BGP session hop-count
limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall?
Drag the statements on the left to the correct OSPF network type on the right.
DRAG DROP
Drag the statements on the left to the correct OSPF network type on the right.