MPLS traffic engineering routing information is carried by:
MPLS traffic engineering routing information is carried by:
Which LSA will be seen in RTA and RTB for those routes?
Refer to the exhibit.
RTE is redistributing some static routes into OSPF as E2. Which LSA will be seen in RTA and
RTB for those routes?
Which byte is tagged on the STM-1 signal to carry out this function?
In SDH the origin of a signal is an important factor in isolating trouble spots. Which byte is tagged
on the STM-1 signal to carry out this function?
Select the best explanation of why Host B will or will not receive the original frame from Host D:
Click the Exhibit button to view the topology.
Host D sends a frame to Host B at the same time that Host B sends a frame to Host D. Bridging is
enabled on Router 1 and the two frames collide into each other. Select the best explanation of
why Host B will or will not receive the original frame from Host D:
Which path is selected as the best path for 10.168.0.1?
Refer to the exhibit.
The next hops are learned via OSPF and IS-IS. Which path is selected as the best path for
10.168.0.1?
What part of the SDH frame can be used to identify and locate trouble between regenerators?
What part of the SDH frame can be used to identify and locate trouble between regenerators?
Would a static route be needed to allow access to other nodes, and in which node would you install it?
Click the Exhibit button.
In the figure, what IP address would you assign to a desktop connected to the TCC port on node
E.Would a static route be needed to allow access to other nodes, and in which node would you
install it?
What will happen if the link between RTA and RTE fails?
Refer to the exhibit.
What will happen if the link between RTA and RTE fails?
How far apart can optical amplifiers be spaced if they can amplify a signal 25 dB, and the cable looses 0.25 d
How far apart can optical amplifiers be spaced if they can amplify a signal 25 dB, and the cable
looses 0.25 dB every kilometer?
When this is detected, the retransmission is sent by:
Click the Exhibit button to view the topology.
Host 1 and Host 2 are on Ethernet LANs in different buildings. A serial line is installed between
two Cisco routers using Cisco HDLC serial line encapsulation. Routers A and B are configured to
route IP traffic. Host 1 sends a packet to Host 2. A line hit on the serial line causes an error in the
packet. When this is detected, the retransmission is sent by: