What happens?
Click the Exhibit button to view the topology.
Routers E and F are configured for HSRP (Hot Standby Routing Protocol). E has a priority of 100,
while F has a priority of 50. At one point, when E is the active router, it fails, and F takes over as
the active router. A few minutes later, E returns to service. What happens?
How much Transport Overhead is contained in a SONET STS-1 frame (excluding VT overhead)?
How much Transport Overhead is contained in a SONET STS-1 frame (excluding VT overhead)?
Which three actions would you take to improve OSPF convergence time?
The core of a network has four routers connected in a square design with Gigabit Ethernet links
using /30 subnets. The network is used to carry voice traffic and other applications. Convergence
time is taking more than expected. Which three actions would you take to improve OSPF
convergence time? (Choose three.)
What is the effective bandwidth of a 6 node, four-fiber OC-48 BLSR ring if all the traffic on the ring is home
What is the effective bandwidth of a 6 node, four-fiber OC-48 BLSR ring if all the traffic on the ring
is homed back to one node (hub-and-spoke) without Protection Channel Access (PCA)?
Calculate the gain of an amplifier if 1 watt is applied to the input and 2 watts is measured at the output:
Calculate the gain of an amplifier if 1 watt is applied to the input and 2 watts is measured at the
output:
What steps can the administrator take to ensure that the "debug" will not require too much CPU…
A network administrator is using debug commands to check the performance of a network. What
steps can the administrator take to ensure that the “debug” will not require too much CPU, or at
least that she will not have to reboot the router to disable debug? (multiple answer)
What can be done to remove the summary routes to Null0 on R3?
Refer to the exhibit.
What can be done to remove the summary routes to Null0 on R3?
which is the highest level of priority in the Intelligent Protection Switching (IPS) hierarchy?
In a Resilient Packet Ring architecture, which is the highest level of priority in the Intelligent
Protection Switching (IPS) hierarchy?
What could be the cause of this issue?
Refer to the exhibit.
R4 is configured as a receive-only EIGRP stub, and is adjacent with 209.165.202.139 (R3).
However, R4 is not learning about network 209.165.201.0/27 from R3. What could be the cause of
this issue?
what occurs?
Click the Exhibit button.
When the G. series card Rx interface at “A” in the diagram loses it’s receive signal, what occurs?