which two EIGRP neighbors will not be queried for alternative paths?
Refer to the exhibit.
After a link flap in the network, which two EIGRP neighbors will not be queried for alternative
paths? (Choose two.)
what node would you put a static route to access this network from an external IP network?
Click the Exhibit button.
With a router connected to node E, and a laptop connected to node C, in what node would you put
a static route to access this network from an external IP network?
Why is AS 65333 in parentheses?
Refer to the exhibit.
Why is AS 65333 in parentheses?
How many of the links in the diagram in blocking mode by STP?
Click the Exhibit button to view the topology.
The diagram shows an L2 switched campus. Switch X is the STP root and switch Y is the standby
root. How many of the links in the diagram in blocking mode by STP?
which TWO statements are necessary conditions?
In order to create a DCC tunnel in the ONS 15454, which TWO statements are necessary
conditions?
1. LDCC tunnels need to be available.
2. The OC-N port where the DCC will be tunneled needs to be enabled.
3. A customer circuit must be provisioned first.
4. Only Ports 1&3 of the OC-3 card can tunnel DCC.
5. SDCC needs to be tunneled separately for transmit and receive directions
What triggered the first SPF recalculation?
Refer to the exhibit.
What triggered the first SPF recalculation?
Which two orders in the BGP Best Path Selection process are correct?
Which two orders in the BGP Best Path Selection process are correct? (Choose two.)
what would the PMD value be (worst-case) if another 30 KM segment is spliced into the original cable with iden
If a 10 KM fiber cable segment has a worst-case PMD value of 1 .Ops, then what would the PMD
value be (worst-case) if another 30 KM segment is spliced into the original cable with identical
fiber specifications?
hown, when is the extinction ratio acceptable?
Click the Exhibit button to view the diagram.
In the OC-48 signal shown, when is the extinction ratio acceptable?
what could be the most likely cause of the problem?
Refer to the exhibit.
R2 and R3 are routers connected using Ethernet services from a service provider and can receive
pings from each other. OSPF is configured as the routing protocol but adjacency is not happening.
According to the output of the show commands in the exhibit, what could be the most likely cause
of the problem?