What would be the most probable reason for this port-ID mismatch?
Refer to the exhibit. Look at the command output. What would be the most probable reason for
this port-ID mismatch?
What is the worst case optical signal-to-noise ratio (OSNR) of Channel 1 at 0.5nm away from the peak?
Click the Exhibit button to view the graph.
The graph represents optical signal power versus wavelength measurement from 1550nm to
1560nm. What is the worst case optical signal-to-noise ratio (OSNR) of Channel 1 at 0.5nm away
from the peak?
Which are correct timing configurations for 7600 interfaces (A) and (B)?
Click the Exhibit button.
The exhibit shows OC-12 POS connections across various transport media. Which are correct
timing configurations for 7600 interfaces (A) and (B)? (Note: connection between routers B and C
is set to internal timing.)
What would be the consequences of this situation?
Refer to the exhibit. Look at the command output. Assume that there is no other path, and the
configuration is correct. What would be the consequences of this situation?
what is the wavelength of the next lower frequency based on a 50GHz channel plan?
Using the ITU-T channel plan recommendation defined in G.692, if one of the channels has a
frequency of 196.10THz (equivalent to 1528.77nm), then what is the wavelength of the next lower
frequency based on a 50GHz channel plan?
what type of transport architecture is best suited for creating an OC-12 RPR ring with 4 Cisco 12000 nodes?
Click the Exhibit button.
In a customer access ring environment, what type of transport architecture is best suited for
creating an OC-12 RPR ring with 4 Cisco 12000 nodes?
What can you use to prevent this behavior?
Refer to the exhibit. Look at the command output. What can you use to prevent this behavior?
what node would you put a static route to access this network from an external IP network?
Click the Exhibit button.
With a router connected to node E, and a laptop connected to node C, in what node would you put
a static route to access this network from an external IP network?
What do directly modulated transponders vary to the laser in order to transmit an optical signal?
What do directly modulated transponders vary to the laser in order to transmit an optical signal?
What is a possible cause of this problem?
Before inserting a new switch in the network, the network administrator checks that the VTP
domain name is correct, the VTP mode is set to server, and revision is lower than the switches in
the network. The administrator then configures interfaces and trunks, erases existing VLANs, and
connects the switch to the network. Following that procedure, there is no connectivity in the
network. What is a possible cause of this problem?