What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?
Refer to the exhibit.
What is the meaning of the term dynamic as displayed in the output of the show frame-relay map
command shown?
Which command would you issue to see where the packets stop?
You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that
a router on the route to an unreachable network is at fault. Which command would you issue to
see where the packets stop?
Which of the following statements is true concerning this command?
The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of
the following statements is true concerning this command?
Which type of gateway would be required?
The XYZ Corporation is migrating from a traditional PBX to a Cisco Unified Communications
system. While the migration is taking place they need to provide common channel signaling
connectivity to the PBX from the Cisco Unified Communications system. Which type of gateway
would be required?
which IP addresses would be assigned to the interfaces with point-to-point PVCs?
In the Frame Relay network,
which IP addresses would be assigned to the interfaces with point-to-point PVCs?
Which of the following are required to solve this?
It has become necessary to configure an existing serial interface to accept a second Frame Relay
virtual circuit. Which of the following are required to solve this? (Choose three)
Which feature does PPP use to encapsulate multiple protocols?
Which feature does PPP use to encapsulate multiple protocols?
What statement about the Cisco Unity Express AIM Module and the Cisco Unity Express Network Module is true?
What statement about the Cisco Unity Express AIM Module and the Cisco Unity Express Network
Module is true?
What is the purpose of LCP?
What is the purpose of LCP?
Which two protocols could be used during this communication?
The network administrator is using a Windows PC application that is called putty.exe for remote
communication to a switch for network troubleshooting. Which two protocols could be used during
this communication? (Choose two).