Which four of these provide information from the existing numbering plan that helps you design an effective Vo
Benson’s Able Messenger Service wants to install a new UC500 solution. Which four of these
provide information from the existing numbering plan that helps you design an effective VoIP dial
plan? (Choose four.)
What does this mean?
The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does
this mean?
What is the cause of the problem?
Refer to the exhibit.
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise,
the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but
the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts
have been verified as correct. What is the cause of the problem?
what two conditions?
An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is
turned on and the switch port link LED turns green. The link light indicates what two conditions?
(Choose two.)
What does the frame-relay interface-dlci command configure?
What does the frame-relay interface-dlci command configure?
What command is missing so that a call to 2002 pages all four phones?
Refer to the exhibit.
When a call is placed to 2000, phones 1 and 2 are paged. A call to 2001 pages phones 3 and 4.
What command is missing so that a call to 2002 pages all four phones?
which statement is correct?
Refer to the exhibit.
The show interfaces serial 0/1 command was issued on the R10-1 router. Based on the output
displayed which statement is correct?
Which statement describes DLCI 17?
Refer to the exhibit.
Which statement describes DLCI 17?
Which inbound dial peer on CMERouter1 will be matched when phone extension 1234 places a call to 2010?
Refer to the exhibit.
Which inbound dial peer on CMERouter1 will be matched when phone extension 1234 places a
call to 2010?
which output value indicates to the local router that traffic sent to the corporate site is experiencing conge
Users have been complaining that their Frame Relay connection to the corporate site is very slow.
The network administrator suspects that the link is overloaded. Based on the partial output of the
Router # show frame relay pvc command shown in the graphic, which output value indicates to the
local router that traffic sent to the corporate site is experiencing congestion?
