What is the purpose of Spanning Tree Protocol?
What is the purpose of Spanning Tree Protocol?
what router ID will OSPF use for this router?
Refer to the exhibit.
Given the output for this command, if the router ID has not been manually set, what router ID will
OSPF use for this router?
Which routers are likely to have been elected as DR?
The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the
graphic. There is concern that a lack of router resources is impeding internetwork performance. As
part of examining the router resources, the OSPF DRs need to be known. All the router OSPF
priorities are at the default and the router IDs are shown with each router.
Which routers are likely to have been elected as DR? (Choose two.)
What does a router do if it has no EIGRP feasible successor route to a destination network and the successor r
What does a router do if it has no EIGRP feasible successor route to a destination network and
the successor route to that destination network is in active status?
Which two dial peers will correctly route calls to emergency services?
Refer to the exhibit.
The Acme Corporation needs assistance in configuring their PSTN voice gateway. Which two dial
peers will correctly route calls to emergency services? (Choose two.)
what information will Router_E contain in its routing table for the subnets 208.149.23.64 and 208.149.23.96?
Refer to the exhibit.
The network is converged. After link-state advertisements are received from Router_A, what
information will Router_E contain in its routing table for the subnets 208.149.23.64 and
208.149.23.96?
Which command is used to display the collection of OSPF link states?
Which command is used to display the collection of OSPF link states?
What is the purpose of assigning a default gateway to SW-C switch?
Exhibit:
Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are
configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each VLAN 1
interface has been assigned the correct IP address. What is the purpose of assigning a default
gateway to SW-C switch?
Which three characteristics apply to ISDN PRI?
Which three characteristics apply to ISDN PRI? (Choose three.)
What is the default administrative distance of OSPF?
What is the default administrative distance of OSPF?