Which feature describes MAC addresses that are dynamically learned or manually configured, stored in the addre
Which feature describes MAC addresses that are dynamically learned or manually configured,
stored in the address table, and added to the running configuration?
Which statement about the minimum requirements to set up stateful failover between these two firewalls is true
Your company is replacing a high-availability pair of Cisco ASA 5550 firewalls with the newer
Cisco ASA 5555-X models. Due to budget constraints, one Cisco ASA 5550 will be replaced at a
time.
Which statement about the minimum requirements to set up stateful failover between these two
firewalls is true?
which interface can port security be configured?
On which interface can port security be configured?
Which signature definition is virtual sensor 0 assigned to use?
Which signature definition is virtual sensor 0 assigned to use?
which port type connects the switch to the gateway router?
When you configure private VLANs on a switch, which port type connects the switch to the
gateway router?
which two modes is zone-based firewall high availability available?
In which two modes is zone-based firewall high availability available? (Choose two.)
which type of port must you configure the gateway router port as?
When you configure a private VLAN, which type of port must you configure the gateway router port
as?
What action will the sensor take regarding IP addresses listed as known bad hosts in the Cisco SensorBase netw
What action will the sensor take regarding IP addresses listed as known bad hosts in the Cisco
SensorBase network?
which statement describes how you will ensure that return traffic will reach the correct context?
You are the administrator of a multicontext transparent-mode Cisco ASA that uses a shared
interface that belongs to more than one context. Because the same interface will be used within all
three contexts, which statement describes how you will ensure that return traffic will reach the
correct context?
Which configuration command ties the router hot standby priority to the availability of its interfaces?
Which configuration command ties the router hot standby priority to the availability of its
interfaces?